Adafruit

MiFare Classic (13.56MHz RFID/NFC) Sticker - 1KB

Art.nr: 362
39 Kr
Lagerstatus: 7
Leveranstid: 1-3 Vardagar
This is a blank MiFare Classic sticker - often used for inventory, identification but also found in other systems where a flexible, thin tag is desired. The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer...
  • Tipsa
    Tipsa en vän
  • Önska
Dela:

This is a blank MiFare Classic sticker - often used for inventory, identification but also found in other systems where a flexible, thin tag is desired. The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away.

These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle MiFare cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino!

These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another - the ID number cannot be changed.

  • S50 chip specification:


    • 1 KiloByte (8 KiloBit) non-volatile EEPROM storage
    • Built in encryption engine with 48-bit key
    • 4 Byte unique identifier burned into the chip
    • 13.56 MHz frequency

  • Tag specification:


    • 41mm x 24mm x 0.2mm / 1.6" x 1" x 0.008"

    • 0.3 grams / 0.01 oz
    • Works about 4" away from reader

  • Downloads: