Adafruit

MiFare Classic (13.56MHz RFID/NFC) Leather Keychain Fob - 1KB

Art.nr: 1482
55 Kr
Lagerstatus: 2
Leveranstid: 1-3 Vardagar
This is a blank MiFare Classic card - often used for train/bus passes but also found in other systems where a proximity card is desired. The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a...
  • Tipsa
    Tipsa en vän
  • Önska
Dela:

This is a blank MiFare Classic card - often used for train/bus passes but also found in other systems where a proximity card is desired. The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away.

These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle MiFare cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino!

These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another - the ID number cannot be changed.

  • S50 chip specification:



    • 1 KiloByte (8 KiloBit) non-volatile EEPROM storage

    • Built in encryption engine with 48-bit key

    • 4 Byte unique identifier burned into the chip

    • 13.56 MHz frequency


  • Tag specification:



    • 38.39mm / 1.51" x 38.39mm / 1.51" x 5.04mm / 0.2"

    • 8.68g

    • Works about 4" away from reader


  • Downloads: