Adafruit

Panel Mount USB Cable - A Male to A Female

Art.nr: 908
79 Kr
Lagerstatus: 2
Leveranstid: 1-3 Vardagar
Ej betygsatt ännu

This handy USB extension cable will make it easy for you to enclose a device that has a A type (USB host) port. We think this would be most handy when putting a Beagle Bone, Raspberry Pi or Mintyboost into a box. The jack half has two mounting 'ears' with 4-40 screws installed, 30mm apart. The ears are flexible so the holes don't have to drilled very precisely. Can be used with box walls up to 0.25" wide. The screws can be put on from the back for 'reverse' mounting if the box thickness is a problem. Entire unit is 13.4" long from tip to tip (with 10.2" cabling between USB connectors).

  • Tipsa
    Tipsa en vän
  • Önska
Dela:

This handy USB extension cable will make it easy for you to enclose a device that has a A type (USB host) port. We think this would be most handy when putting a Beagle Bone, Raspberry Pi or Mintyboost into a box. The jack half has two mounting 'ears' with 4-40 screws installed, 30mm apart. The ears are flexible so the holes don't have to drilled very precisely. Can be used with box walls up to 0.25" wide. The screws can be put on from the back for 'reverse' mounting if the box thickness is a problem. Entire unit is 13.4" long from tip to tip (with 10.2" cabling between USB connectors).

Panel mount USB type A socket with USB type A plug at cable end

28 AWG data,

24 AWG power wires Shielded with wire braid

As of May 9th, 2014 the dimensions are:

13.4" / 340mm long from tip to tip

10.2" / 259 mm cable length between USB connectors

Two 10mm 4-40 mounting screws, 30mm apart

Weight: 27g

Omdömen (0)
Du måste logga in för att kunna skriva omdömen Logga in
  • Inga omdömen har lämnats för denna produkt

    Bli först med att skriva ett!